The cosmetic effect of BTX-A on wrinkles was originally documented by a plastic surgeon from Sacramento, California, Richard Clark, and published in the journal Plastic and Reconstructive Surgery in 1989. Canadian husband and wife ophthalmologist and dermatologist physicians, JD and JA Carruthers, were the first to publish a study on BTX-A for the treatment of glabellar frown lines in 1992. Similar effects had reportedly been observed by a number of independent groups (Brin, and the Columbia University group under Monte Keen.) After formal trials, on April 12, 2002, the FDA announced regulatory approval of botulinum toxin type A (Botox Cosmetic) to temporarily improve the appearance of moderate-to-severe frown lines between the eyebrows (glabellar lines). Subsequently, cosmetic use of botulinum toxin type A has become widespread. The results of Botox Cosmetic can last up to four months and may vary with each patient. The US Food and Drug Administration approved an alternative product-safety testing method in response to increasing public concern that LD50 testing was required for each batch sold in the market.
If the musculature of the oropharynx and esophagus are affected, aspiration may occur which may lead to development of aspira tion pneumonia. If the respiratory muscles become paralyzed or sufficiently weakened, intubation and assisted respiration may be necessary until recovery takes place. Supportive care could involve the need for a tracheostomy and/or prolonged mechanical ventilation, in addition to other general supportive care.
* LS mean change, treatment difference and p-value are based on an analysis using an ANCOVA model with baseline weekly endpoint as covariate and treatment group, etiology at study entry (spinal cord injury or multiple sclerosis), concurrent anticholinergic therapy at screening, and investigator as factors. LOCF values were used to analyze the primary efficacy variable.
According to the PREEMPT injection paradigm, 5 units of onabotulinumtoxinA is to be administered to two sites on each side for a total dose of 20 units across four sites in the cervical paraspinal muscle group near the midline. The first injection site is approximately 1 cm left of the midline of the cervical spine and approximately 3 cm (2 fingerbreadths) inferior to the occipital protuberance. The second site is measured approximately 1 fingerbreadth diagonally up at a 45° angle from the first injection. The injections should be administered in the most superficial aspect of the muscle, angling the needle 45° and superiorly. To aid in the placement of the injections, the patient should be positioned upright with the head in a neutral position. If the neck is flexed too far forward, injections may be too deep. Injections that are too low or too deep in this muscle group can lead to muscle weakness and neck pain. Injectors should use a suboccipital approach to ensure that the injection sites are not too low. In addition, a horizontal line can be visualized across the neck, approximately 2 fingerbreadths down from the occipital protuberance, to make certain the injections remain above the line and are not administered too low in the neck. The higher these injections are, the more likely that they will be in the muscle fascial condensation, which will minimize the potential for neck weakness. These injections should not be done below the hairline. Patients who have trigger points in the neck should not be injected at these sites as these are generally areas where muscles may be weakened and injections of onabotulinumtoxinA at these sites might worsen their neck issues.
It's a remarkable arc for a drug that only a few years ago was associated with Hollywood cocktail parties where guests came for Bellinis and left with a forehead full of Botox injections. It highlights the advances that can occur when physicians, seeking new therapies for their patients, explore creative new uses for approved drugs--basically, real-world experiments that take place largely beyond the reach of federal regulators. That, in turn, raises questions about the risks of deploying medicines in ways that have not been fully vetted. But it happens all the time.
How much is Botox is a frequent question we get in our dermatology offices. The cost of Botox runs typically about $400 – $600 per first treatment area, and up to $300 for each additional area. The most popular areas for Botox treatment are the glabella (those lines in between your eyebrows also known as the “11’s”), the crow’s feet are around the eyes and the horizontal lines on the forehead. When injected by a trained professional who has experience with facial aesthetics, Botox can also give the brows and eye area a mini eye lift. When Botox injections are performed by a trained, licensed and experienced medical expert, the results can be amazing. You will not appear frozen or as though you’ve had work done, when injected properly, Botox makes you look more relaxed, more rejuvenated and just better than before. It’s important to seek out a professional who knows about facial anatomy and can inject you in the exact right places.
With the outbreak of World War II, weaponization of botulinum toxin was investigated at Fort Detrick in Maryland. Carl Lamanna and James Duff developed the concentration and crystallization techniques that Edward J. Schantz used to create the first clinical product. When the Army’s Chemical Corps was disbanded, Schantz moved to the Food Research Institute in Wisconsin, where he manufactured toxin for experimental use and generously provided it to the academic community.
Spread of toxin effects. The effect of botulinum toxin may affect areas away from the injection site and cause serious symptoms including: loss of strength and all-over muscle weakness, double vision, blurred vision and drooping eyelids, hoarseness or change or loss of voice, trouble saying words clearly, loss of bladder control, trouble breathing, trouble swallowing.
After working out techniques for freeze-drying, buffering with albumin, and assuring sterility, potency, and safety, Scott applied to the FDA for investigational drug use, and began manufacturing botulinum type A neurotoxin in his San Francisco lab. He injected the first strabismus patients in 1977, reported its clinical utility in 1980, and had soon trained hundreds of ophthalmologists in EMG-guided injection of the drug he named Oculinum ("eye aligner").
Treatment with BOTOX and other botulinum toxin products can result in swallowing or breathing difficulties. Patients with preexisting swallowing or breathing difficulties may be more susceptible to these complications. In most cases, this is a conseq uence of weakening of muscles in the area of injection that are involved in breathing or oropharyngeal muscles that control swallowing or breathing [see Spread Of Toxin Effect].
When most people see the results of Botox, they are extremely pleased. Botox’s ability to iron out wrinkles is pretty impressive. The fine lines and wrinkles that were all you could see in the mirror appear much less severe and the overall appearance is refreshed and more relaxed and rejuvenated. Botox results typically last up to six months. Botox also acts as a preventative measure for wrinkles, as it prevents repetitive folding of the skin that come from the frequency of making expressions. By injecting Botox before wrinkles even form, you’re setting the stage for a younger look for years to come.
There are no data on the presence of BOTOX in human or animal milk, the effects on the breastfed child, or the effects on milk production. The developmental and health benefits of breastfeeding should be considered along with the mother's clinical need for BOTOX and any potential adverse effects on the breastfed infant from BOTOX or from the underlying maternal conditions.
Do not receive BOTOX® Cosmetic if you: are allergic to any of the ingredients in BOTOX® Cosmetic (see Medication Guide for ingredients); had an allergic reaction to any other botulinum toxin product such as Myobloc® (rimabotulinumtoxinB), Dysport® (abobotulinumtoxinA), or Xeomin® (incobotulinumtoxinA); have a skin infection at the planned injection site.