The effects of botulinum toxin are different from those of nerve agents involved insofar in that botulism symptoms develop relatively slowly (over several days), while nerve agent effects are generally much more rapid and can be instantaneous. Evidence suggests that nerve exposure (simulated by injection of atropine and pralidoxime) will increase mortality by enhancing botulinum toxin's mechanism of toxicity.
Botulinum toxin has been investigated for use in patients with blepharospasm in several studies. In an open label, historical ly controlled study, 27 patients with essential blepharospasm were injected with 2 Units of BOTOX at each of six sites on each side. Twenty-five of the 27 patients treated with botulinum toxin reported improvement within 48 hours. One patient was controlled with a higher dosage at 13 weeks post initial injection and one patient reported mild improvement but remained functionally impaired.
The seven toxin types (A-G) have different tertiary structures and sequence differences. While the different toxin types all target members of the SNARE family, different toxin types target different SNARE family members. The A, B, and E serotypes cause human botulism, with the activities of types A and B enduring longest in vivo (from several weeks to months).
The patient is placed in a somewhat raised position on the exam table, and the areas to be injected are cleansed with a nonalcohol cleanser, such as Hibiclens or Betadine. Some physicians will apply a topical anesthetic, such as EMLA cream or some alternative, at this time. The Botox is then injected into the desired areas. Typical injection patterns include about four or five areas on each side of the forehead and two or three areas on either eye area. More areas can be injected by skilled physicians, depending on the type of wrinkles and the desired effect for the patient. It is common for pressure to be applied if an area seems to be bleeding after the injection. While ice is sometimes applied beforehand for comfort reasons, direct pressure is much more effective than ice for control of bleeding and bruising.
According to the PREEMPT injection paradigm, a total of 5 units of onabotulinumtoxinA is injected into each corrugator muscle. To confirm the location of the muscle, the patient is asked to furrow the brow in order to activate the corrugator. Once the muscle has been located, the muscle should be palpated and pinched by holding it between the thumb and index finger. Five units of onabotulinumtoxinA is injected at an approximate 90° angle with the bevel of the needle pointing upward into the medial belly of the muscle. As the needle is inserted, there is skin resistance, which lessens when the muscle is penetrated. This decrease in resistance is termed a muscle pop. Once the muscle pop occurs, inject into the superficial muscle. If the injection is too far superior or above the corrugator muscle, brow ptosis can occur due to depression of the medial brow as the frontalis elevating function is lost and the corrugator depressing function remains unopposed. Whereas weakening the corrugator muscle will cause elevation of the medial eyebrow, alternatively, if the corrugator injection is done too low, then diffusion to the levator palpebral muscle could lead to lid ptosis.
This medication is given by injection by an experienced health care professional. It is injected into the affected muscles (intramuscularly) when treating eye disorders, muscle stiffness/spasms, and wrinkles. When used to prevent migraines, it is injected into the muscles of the head and neck. It is injected into the skin (intradermally) for the treatment of excessive sweating. For the treatment of drooling/excess saliva, this medication is injected into the salivary glands. When treating overactive bladder, it is injected into the bladder.
Oral CareChildren's Oral Care,Dental Floss & Gum...1187 Personal CareBody Treatments,Deodorants & Antiperspir...3490 Sexual WellnessAdult Books,Anal Toys,Arousal & Massage...4262 Shaving & GroomingHair Removal,Men's Shave,Shave Accessori...1296 Skin CareCellulite & Stretch Marks,Cleanse,Exfoli...7722 Vitamins & SupplementsDetox & Superfoods,Protein,Sports Nutrit...4185
Prior to injection, reconstitute each vacuum-dried vial of BOTOX with only sterile, preservative-free 0.9% Sodium Chloride Injection USP. Draw up the proper amount of diluent in the appropriate size syringe (see Table 1, or for specific instructions for detr usor overactivity associated with a neurologic condition see Section 2.3), and slowly inject the diluent into the vial. Discard the vial if a vacuum does not pull the diluent into the vial. Gently mix BOTOX with the saline by rotating the vial. Record the date and time of reconstitution on the space on the label. BOTOX should be administered within 24 hours after reconstitution. During this time period, reconstituted BOTOX should be stored in a refrigerator (2° to 8°C).
BOTOX® treats the symptoms of severe underarm sweating when topical medicines do not work well enough in people 18 years and older. It is not known whether BOTOX® is safe or effective for severe sweating anywhere other than your armpits. BOTOX® treatments temporarily block the chemical signals from the nerves that stimulate the sweat glands, resulting in reduced sweating.