The overall cost of the injection is charged either at a flat rate or per unit. In terms of per unit, the overall cost of the treatment will depend on the total volume or a total number of units used in the procedure. But service charged at a flat rate depends on the area to be treated. The most expensive area is around the underarm for treating hyperhidrosis.
In both studies, significant improvements compared to placebo in the primary efficacy variable of change from baseline in wee kly frequency of incontinence episodes were observed for BOTOX (200 Units) at the primary efficacy time point at week 6. Increases in maximum cystometric capacity and reductions in maximum detrusor pressure during the first involuntary detrusor contraction we re also observed. These primary and secondary endpoints are shown in Tables 21 and 22, and Figures 7 and 8.
The recommended dilution is 200 Units/2 mL, 200 Units/4 mL, 100 Units/1 mL, or 100 Units/2 mL with preservative-free 0.9% Sodium Chloride Injection, USP, depending on volume and number of injection sites desired to achieve treatment objectives (see Table 1). In general, no more than 50 Units per site should be administered using a sterile needle (e.g., 25-30 gauge) of an appropriate length. Localization of the involved muscles with electromyographic guidance may be useful.
Kybella helps patients lose their dreaded double chin and regain the taut, sculpted profile of their youth. The ingredients in Kybella are naturally made by the body, which means that you’re very likely to be satisfied with the results. It works by destroying the fat cells under the chin, making them unable to store fat any longer. Each treatment only requires 15-20 minutes, which leaves enough time to grab some sushi before you head back to the office. You’ll pay out somewhere between $1200 and $1800, but a chin tuck can cost anywhere from $1500 to $4000. Plus, Kybella doesn’t require the healing time that traditional skin liposuction does.
Prior to injection, reconstitute each vacuum-dried vial of BOTOX with only sterile, preservative-free 0.9% Sodium Chloride Injection USP. Draw up the proper amount of diluent in the appropriate size syringe (see Table 1, or for specific instructions for detr usor overactivity associated with a neurologic condition see Section 2.3), and slowly inject the diluent into the vial. Discard the vial if a vacuum does not pull the diluent into the vial. Gently mix BOTOX with the saline by rotating the vial. Record the date and time of reconstitution on the space on the label. BOTOX should be administered within 24 hours after reconstitution. During this time period, reconstituted BOTOX should be stored in a refrigerator (2° to 8°C).
Focal Spasticity is a condition in which certain muscles in your body become stiff or tight. It is caused by damage to parts of the central nervous system that control voluntary movements. When this happens, your nerves send continuous messages to your muscles telling them to contract, or tighten. If you or someone you care for has stiffness in the muscles of the elbow, wrist, fingers, thumb, ankle, or toes, it could be Focal Spasticity.1